1.35-1.535GHz
Antenna Inputs.All antenna VSWR value are specified with
7/8" EIA connectors. Other optional inputs may result in
equal or slightly higher VSWR.
Pressurization. Feeds are pressurizable to 10 Ib/in2 (70 kPa)
Type Number |
Diameter ft(m) |
Gain, dBi Mid- Band |
VSWR max.(R.L.,dB) |
|
|
4(1.2) |
22.3 |
1.3(17.7) |
|
|
6(1.8) |
25.8 |
1.3(17.7) |
|
|
8(2.4) |
28.7 |
1.3(17.7) |
|
|
|
|
|
|
|
4(1.2) |
22.4 |
1.3(17.7) |
|
|
6(1.8) |
25.9 |
1.3(17.7) |
|
|
8(2.4) |
28.8 |
1.3(17.7) |
|
|
10(3.0) |
30.3 |
1.3(17.7) |
|
|
12(3.7) |
31.8 |
1.3(17.7) |
|
|
|
|
|
|
|
3(0.9) |
21.4 |
1.5(14.0) |
|
|
4(1.2) |
23.8 |
1.3(17.7) |
|
|
6(2.0) |
27.2 |
1.2(20.8) |
|
|
8(2.4) |
29.4 |
1.2(20.8) |
|
|
10(3.0) |
30.7 |
1.2(20.8) |
|
|
|
|
|
|
|
3(0.9) |
20.1 |
1.35(16.5) |
|
|
4(1.2) |
23.6 |
1.35(16.5) |
|
|
6(2.0) |
27.0 |
1.35(16.5) |
|
|
8(2.4) |
28.8 |
1.30(17.7) |
|
|
10(3.0) |
30.5 |
1.30(17.7) |
|
|
13(4.0) |
32.9 |
1.30(17.7) |
|
|
 FPHP Antennas
FPHP antennas combine the traditional focal plane reflector with the added electrical performance of narrow shielded antennas. The added performance is obtained through the use of an integrated shield located within the molded radome, included with the antenna. These antennas are available in the 1.3 GHz band and are ETSI type approved. |
Standard Focal Plane Antennas
FP and FPX Series Standard Focal Plane antennas are ideal for use in higher capacity systems where improved front-to-back ratios are required.
- Special deep reflectors and a unique beam-shaping feed or special edge geometry achieve efficient pattern performance. The antennas combine reasonable initial cost with very long-life performance, assuring long term economy.
- Single and dual polarization options are available
- A vertical tower mount for ease of tower interface is included
|
 KP, KPR F-Series GRIDPAK® Antennas
Andrew KP and KPR F-Series Parabolic GRIDPAK antennas are solutions for low wind loading situations. These grid antennas are single polarized either horizontally or vertically, depending on assembly configuration and typically operate in bands below 3.7 GHz. KP and KPR F-Series Parabolic GRIDPAK antennas use foam-filled feeds, eliminating pressurization requirements. This type of feed also acts as a gas barrier when air dielectric transmission line is used.
The KPR F-Series antennas are suitable for low to medium capacity systems such as Rural Telephony Multi-Access Radio Systems (MARS). They incorporate a HELIAX® foam cable jumper assembly in the feed design. This jumper assembly can be terminated with any connector that can be fit onto Andrew LDF4-50A HELIAX coaxial cable. |
|
